page 12
Diagram 5
Route the cable.
Route cable
through hole.
Diagram 4
4. Remove the shipping fasteners from the front panel. Diagram 4. With the
supplied hex key and a ½-inch box end wrench, loosen and remove the 4 bolts,
washers and nuts on the front panel. These fasteners are used during shipping to
hold the front plate in place. Discard the fasteners.
5. Remove any tape or wire ties securing the display cable to the side of the unit.
6. Route the display cable. Diagram 5. Have your assistant hold the right upright
support close to the base while you route the cable through it.
Note: The left or right side of the treadmill can be determined when you stand at
the rear of the running bed and face the motor.
CAUTION: To avoid damage to the display
cable, read and follow these steps care-
fully. Damage to the cable due to improper
assembly is not covered by the Precor
limited warranty.
Remove the shipping
fasteners from the
front plate.
Front panel
Shipping fasteners
found on right and
left sides of the front
panel.
Right side
mounting bracket
Right side upright
support
Display cable
To Next Page
Loading...
