Precor C932i Service Manual

C932i, C946i Treadmill
Page 26
12. Set the treadmill’s on/off switch in the “off” position. Visually inspect the incline motor’s
wiring and connector for any broken or improperly crimped connections. With an ohmmeter,
measure between terminals 1 & 5 and 1 & 6 of the INCLINE connector. Both readings
should be approximately 12Ω. If either reading is significantly high or open replace the
incline motor.
13. If you have performed all of the procedures above and have been unable to correct the
problem, call Precor customer service.
14. Set the treadmill’s on/off switch in the “off” position. Remove the incline motor’s connector
from the INCLINE connector on the power control module. Visually inspect the incline
motor’s wiring and connector for any broken or improperly crimped connections. With an
ohmmeter, read between terminals 3 & 4, 4 & 8 and 3 & 8 of the INCLINE connector.
Terminals 3 & 4 should read approximately 1KΩ. The sum of the readings between
terminals 4 & 8 and 3 & 8 should total approximately 1KΩ. If either reading is significantly
high or open, replace the incline motor.
15. If you have performed all of the procedures above and have been unable to correct the
problem, call Precor customer service.

Precor C932i Specifications

Power

motor power	2.75 hp
power supply	120 VAC (50/60Hz)
current	15 Amps

Performance

speed range	0.5 - 11 mph (1 - 18 kph)
incline range	0 - 15% grade

Weight and Dimensions

length	79 in (201 cm)
width	34 in (84 cm)
height	55 in (140 cm)
weight	280 lbs (126 kg)
shipping weight	320 lbs (144 kg)
belt dimensions	57 in x 20 in (145 cm x 51 cm)