C932i, C946i Treadmill
20077-112 Page 43
Procedure 6.6 - Replacing the Line Filter
1. Set the treadmill circuit breaker in the “off” position and unplug the treadmill’s line cord from
the A.C. outlet.
2. Remove the treadmill’s hood.
3. Remove the two screws that fastens the A.C. input panel to the frame,. See Diagram 6.4.
4. Disconnect the wiring from the A.C. line filter (2 blue wires, 2 brown wires and a green/
yellow wire.
5. Lift the A.C. input panel from the frame and rotate it to expose the A.C. line filter mounting
screws. See Diagram 6.5.
6. Remove the screws that retain the A.C. line filter. Remove the A.C. line filter.
7. Set the replacement A.C. line filter in its mounting position with the side with three terminals
facing the circuit breaker.
8. On 120 Vac and 240 Vac treadmills, connect the blue wire from the power control module to
the L1 terminal on the “LOAD” side of the A.C. line filter and the brown wire from the power
control module to the L2 terminal on the “LOAD” side of the A.C. line filter.
9. On 120 Vac treadmills, connect the blue wire from the input module to the L1 terminal on the
“LINE” side of the A.C. line filter, the brown wire from the circuit breaker to the L2 terminal on
the “LINE” side of the A.C. line filter and the green/yellow wire to the terminal mounted
directly on the line filter case.
10. On 240 Vac treadmills, connect the blue wire from the circuit breaker to the L1 terminal on
the “LINE” side of the A.C. line filter, the brown wire from the circuit breaker to the L2
terminal on the “LINE” side of the A.C. line filter and the green/yellow wire to the
(annunciated) terminal mounted directly on the line filter case.
11. Set the input panel in its mounting position and fasten it with the hardware removed in step
3.
12. Thoroughly check the treadmill per Section 3.
To Next Page
Loading...
Need help?
Power
Performance
Weight and Dimensions
