Precor C932i Service Manual

C932i, C946i Treadmill
Page 42
6. Remove the two screws retaining the circuit breaker and remove the circuit breaker.
7. Reference the label on the replacement circuit breaker and set the circuit breaker in its
mounting position with the “LINE” side of the breaker facing the input module and the
“LOAD” side of the circuit breaker facing the A.C. line filter. Fasten the circuit breaker with
the hardware removed in step 6.
8. On 120 Vac treadmills connect the blue wire from the input module to the “LINE” terminal on
the circuit breaker and the blue wire from the A.C. line filter to the “LOAD” terminal on the
circuit breaker.
9. On 240 Vac treadmills connect the blue wire from the input module to the upper “LINE”
terminal on the circuit breaker and the blue wire from the A.C. line filter to the upper “LOAD”
terminal on the circuit breaker. Connect the brown wire from the input module to the lower
“LINE” terminal on the circuit breaker and the brown wire from the A.C. line filter to the lower
“LOAD” terminal on the circuit breaker.
10. Set the input panel in its mounting position and fasten it with the hardware removed in step
3.
11. Thoroughly check the treadmill per Section 3.

Precor C932i Specifications

Power

motor power	2.75 hp
power supply	120 VAC (50/60Hz)
current	15 Amps

Performance

speed range	0.5 - 11 mph (1 - 18 kph)
incline range	0 - 15% grade

Weight and Dimensions

length	79 in (201 cm)
width	34 in (84 cm)
height	55 in (140 cm)
weight	280 lbs (126 kg)
shipping weight	320 lbs (144 kg)
belt dimensions	57 in x 20 in (145 cm x 51 cm)