Precor C932i - Hardware Kit and Tools

C932i, C946i Treadmill
Page 10
Procedure 2.3 - Setting Club Parameters
This procedure allows you to change the following club settings:
• Safety Code
• Select Language
• Select Units
• Set Max Workout Time
• Set Max Pause Time
• Set Cool Down Time
• Set Speed Limit
• Set Incline Limit
• Hidden Programs (C932i only)
• Remote Speed Control
Procedure
1. Plug the power cord into the wall outlet, then turn on the treadmill with the circuit breaker.
2. With the banner scrolling, press keys RESET,5,6,5,1,5,6,5, sequentially.
3. DIAGS-SET CLUB PARAMETERS will scroll across the display.
4. Use the , keys to move to the desired display shown in the list above.
5. SAFETY CODE display. The safety code, when enabled, makes the user enter a password
in order to start the treadmill. Press the OK key.
6. Use the , keys to toggle between ENABLED and DISABLED.
7. Press the Clear key (C932i) or BA.C.K key (C946i) then the  key, SELECT LANGUAGE
will be displayed.
8. SELECT LANGUAGE display. Press the OK key.
9. Use the , keys to toggle between the available languages.
10. Press the Clear key (C932i) or BA.C.K key (C946i) then the  key, SELECT UNITS will be
displayed.
11. SELECT UNITS display. Press the OK key.
12. Use the , keys to toggle between U.S (miles per hour) and METRIC (kilometers per
hour).
13. Press the Clear key (C932i) or BA.C.K key (C946i) then the  key, SET MAX WORKOUT
TIME will be displayed.