C932i, C946i Treadmill
Page 64
Procedure 6.17 - Running Belt and/or Deck Replacement
Note: Two running belt gauges, Precor part number 20007-101, are required. It is important
that this procedure be followed to maintain correct drive belt and running belt
tension. Over tensioning the belt will lead to premature running belt wear,
premature driver roller bearing failure and premature take up roller bearing failure.
1. Remove the end caps from the rear of treadmill to expose the take up roller mounting bolts.
Remove the treadmill’s motor cover.
2. If applicable, remove the finger guard from in front of the take up roller.
3. Remove both running deck trim strips and both take up roller mounting bolts. Remove the take up
roller from the treadmill.
4. Slowly rotate the drive motor flywheel while pressing the drive belt off of the drive roller
pulley. Continue until the drive belt walks completely off of the drive roller pulley.
To Next Page
Loading...
Need help?
Power
Performance
Weight and Dimensions
