Precor C932i Service Manual

C932i, C946i Treadmill
Page 8
Procedure 2.2 - Displaying Information
The information display will access the following data;
• Odometer
• Hour Meter
• U-Boot Software
• U-Base Software
• Lower Software
• Serial Number
• Usage log
• Error Log
Procedure
1. Plug the power cord into the wall outlet, then turn on the treadmill with the circuit breaker.
2. With the PRECOR banner scrolling, press the keys RESET,6,5, sequentially.
3. DIAGS-INFORMATION DISPLAY will scroll across the display.
4. Use the , keys to move to the desired display shown in the list above.
5. ODOMETER display. Press the OK key.
6. The odometer will be displayed as 1234567 MILES or 1234567 KM depending on club
parameter settings (See Procedure 2.3). The odometer is also used to provide the “distance
stamp” for the error code log
Note: The odometer data is stored in non-volatile memory on the upper PCA. If the upper PCA
is replaced the odometer data will be lost.
7. Press the Clear key (C932i) or BA.C.K key (C946i) then the  key, HOUR METER will be
displayed.
8. HOUR METER display. Press the OK key.
9. The operating time of the unit will be displayed as 12345 HOURS. The operating time is
defined as total amount of time that the unit has operated in program modes with the drive
motor running. The hour meter is also used to provide the “time stamp” for the error code
log.
10. Press the Clear key (C932i) or BA.C.K key (C946i) then the  key, U-BOOT SW will be
displayed
11. U-BOOT SW display. This display the installed version of upper boot software. The boot
software is used to upload new software into the upper display PCA.

Precor C932i Specifications

Power

motor power	2.75 hp
power supply	120 VAC (50/60Hz)
current	15 Amps

Performance

speed range	0.5 - 11 mph (1 - 18 kph)
incline range	0 - 15% grade

Weight and Dimensions

length	79 in (201 cm)
width	34 in (84 cm)
height	55 in (140 cm)
weight	280 lbs (126 kg)
shipping weight	320 lbs (144 kg)
belt dimensions	57 in x 20 in (145 cm x 51 cm)