Daily Inspection
You will need to perform the following tasks each day to maintain the
equipment and keep it operating smoothly:
Clean any upholstery on the equipment.
Inspect pads for wear.
Clean and inspect equipment frames.
Inspect cables and end connections for wear.
Check warning and instructional labels.
Check that all fasteners are properly secured.
Perform the tasks that are appropriate for the equipment you are maintaining,
and skip the tasks that do not apply.
Clean Upholstery
To remove surface dirt and perspiration, clean upholstery daily with a mild
soap and water solution in a spray bottle. Spray upholstered surfaces lightly
and wipe dry with a clean cloth.
Important: To clean the upholstery, do not use cleaning products that have any of
these ingredients: solvents, alcohol, ammonia, or petroleum. Use a mild
detergent-based cleaner instead.
Clean Shroud
CAUTION: To avoid damage to the shrouds, clean them according to the
instructions in this section. Use a clean, non-abrasive cloth and light
pressure to avoid scratching the surface.
To clean the shrouds, Precor recommends mixing a few drops of mild
dishwashing liquid in a gallon of water and using it to wipe the equipment with
a soft cloth. Wipe the soap off using another soft cloth and clean water.
The shrouds are easily scratched or damaged through improper cleaning
techniques. To avoid problems, dust the shrouds often with a clean, lint-free
cloth and light pressure. Avoid rubbing dirt or grit into the surface.
Important: DO NOT use ketones, aromatics, esters, window cleaning sprays,
alcohol, kitchen scouring compounds, ammonia-based cleaning solutions or solvents
(such as acetone, benzene, gasoline, carbon tetrachloride, or thinners).
To Next Page
Loading...
Need help?
General
