EFX 200 Series Assembly Guide 12
Adjusting the Ramp (EFX Models 222 and 221
Only)
The EFX ramp incline can be set to one of three positions: Low (15 degrees),
Medium (20 degrees), or High (25 degrees). If you are on the equipment,
dismount. To adjust the ramp, you can straddle the equipment with one foot on
either side or stand to one side of it.
CAUTION: To adjust the ramp, you must be standing on the floor. You cannot be
standing on the equipment or the foot pedals. Be aware of the position of the handrails
and console when you are adjusting the ramp. Be careful not to bump your head on the
console when you stand up.
To adjust the ramp:
1. Place one hand under the front of the ramp and one hand on the lever. Pull the
front of the ramp up and toward you while pulling the lever back and up. This
releases the ramp for adjustment.
Figure 24: Ramp adjustment
2. Carefully adjust the ramp to the desired height.
Important: Before releasing your grip, test the ramp by gently pushing it down with
your hands to make sure that it has securely clicked into one of the incline positions.
The ramp should not move when tested.
To Next Page
Loading...
Need help?
General
