EFX 200 Series Assembly Guide 4
Assembling the Equipment
Proper alignment and adjustment of the equipment is critical. When you install
fasteners, leave room for adjustments. Do not fully tighten the fasteners until you are
instructed to do so.
The following figure identifies the major components of the equipment referred to
in this manual. Your equipment may look slightly different based on the model.
Figure 1: Major components of EFX
Beginning Assembly
Note: For easier access to the base frame, lift the front of the EFX off the floor and
place a wedge of packaging cardboard beneath its base.
To connect the base cable:
1. Ask your assistant to hold the left stabilizer next to the base frame and attach
it using four M8 x 20 mm hex head bolts and four M8 washers. Partially
tighten the fasteners.
Figure 2: Left stabilizer attachment
To Next Page
Loading...
