EFX 400 Series Assembly Guide 20
Changing the EFX 447 from Moving Arms to
Fixed Arms
The EFX 447 is assembled with movable arms; however, this model includes an
option that allows you to convert the movable arms to fixed arms.
To convert to fixed arms:
1. Disconnect the socket end of the lower link arm from the pedal frame by
pressing the pin on the socket end and pulling it outward.
Figure 42: Location of pin on socket end of lower link arm
2. Twist the socket end toward the floor and insert the pin into the quick pin
release socket on the base frame in front of the back cover.
Figure 43: Changing socket end position
3. Repeat the previous two steps for the pedal on the opposite side of the EFX.
Figure 44: Position of socket end in base frame
4. To convert the EFX back to moving arms, perform this procedure in reverse
order.
To Next Page
Loading...
Need help?
General
