Precor EFX5.33 - Page 17

page 17
15. Attach the handlebars to the pivot arm. Diagram 13. Take the following steps
to attach the handlebars to the pivot arm.
Note: Proceed with one handlebar at a time. When you have completed the
installation steps for one, perform the same steps for the opposite handlebar.
a. Remove the shoulder bolt (C) from the Hardware kit.
b. For ease of installation, slide the foot pedal to the top of the ramp.
c. On the same side, align the mounting holes on the handlebar and the pivot arm.
d. Insert the shoulder bolt. Secure the handlebar to the lower pivot arm using the
hex key provided. Tighten the bolt securely. See Diagram 13.
Diagram 13 Secure the
handlebars to the
pivot arm.
Diagram 14 Secure the
bracket cover.
16. Attach the bracket cover. Diagram 14. Take the following steps to attach the
cover over the upright support bracket.
a. Move the handlebars out of the way.
b. Locate the two screws beneath the upright support bracket. Remove each
one using a phillips head screwdriver.
c. Place the bracket cover over the upright support and align the mounting
holes. See Diagram 14.
d. Reinsert the two screws and tighten securely. Do not tighten too much or
you may inadvertently crack the plastic mounts.
CAUTION: Do not overtighten the screws
or you may inadvertently cause stress
cracks in the plastic.
Shoulder bolt (C)
Handlebar
5/16" Hex key
Pivot arm
Bracket cover
Upright support
bracket