page 13
COMMERCIAL PRODUCTS DIVISION
d. Align the mounting holes and insert the four screws (A) and washers (B)
through the upper column support and into the base support mounting
bracket. Refer to Diagram 3. Finger-tighten each screw. Do not fully
tighten the screws until the front cover is in place.
Diagram 4
Attaching the front cover.
5. Take the following steps to attach the front cover.
a. Place the front cover onto the base so that it encloses the lift motor and
aligns over the lift bars as shown in Diagram 4. Do not scrape off the foam
tape that is adhered to the edges inside the front cover. It provides
insulation between the upper column support and front cover.
b. Use the twelve button head screws (C) found in the hardware kit to
secure the cover to the base assembly and upper column support. Lift
the cover slightly and move it forward toward the column before inserting
the screws. Finger-tighten the screws at this point. Do not use the hex
key.
c. Return to the column screws (A) on the upper column support. Alter-
nately tighten each screw using the supplied hex key until all four screws
are secure and tight against the column. Do not over tighten.
d. Use the hex key (E) and alternately tighten the front cover screws.
Foam tape
Upper column support
Front cover
Lift bar
To Next Page
Loading...
