page 15
COMMERCIAL PRODUCTS DIVISION
Installing the handrails.
Diagram 7
Upper column support
Lower clamp
Lower handrail
Foam grip on handrail
Upper handrail
CAUTION: The assembled unit will not fit through a standard doorway.
Before installing the handrails, make sure that the EFX544 is located
where you plan to use it.
8. Insert the handrails one at a time. See Diagram 7 for the proper orientation.
Align the upper and lower portion of the handrail with the clamps. Slide the
handrail into the clamps until the black foam grip on the handrail touches the
clamps. Perform the same step on the opposite handrail.
9. Securely tighten the bolts in the handrail clamp using the hex key (F)
provided.
10. Cover the bolt holes on the handrail clamps with the four black plastic caps
found in the hardware kit.
11. Remove the two bolts (D) from the hardware kit and carefully remove any
packing materials from around the electronic console.
Ribbon cable
Reading rack
To Next Page
Loading...
