Precor EFX556i - Determining the Units of Measure; Setting a Workout Time Limit; Setting a Pause Time Limit; Viewing the Odometer, Hours of Use, Software Version and Error Log

page 20
COMMERCIAL PRODUCTS DIVISION
DETERMINING THE UNITS OF MEASURE
Two different units of measure can be selected, Metric or U.S. Standard . Make your
selection using the ▼▲ keys. Press ENTER once the correct unit is displayed.
Note: Anytime you wish to exit the Club Custom mode, press the RESET key.
Any previous display attributes that you selected by pressing ENTER are saved
and recorded in memory.
SETTING A WORKOUT TIME LIMIT
You can limit how long a user works out by setting a duration between 1 and 240
minutes. The EFX also lets you choose “no limit” which allows the user to select a
program and work out indefinitely. (Note that the user must enter a workout time of 0
using the numeric keys at the ENTER TIME prompt before working out “indefinitely.”)
Important: If the club setting is “no limit” and the user enters “0” at the ENTER
TIME prompt, then the REMAINING TIME display does not appear when a user
works out. (An exception to this rule is the Weight Loss Program.)
Note: The QuickStart program is set at the Club limit (see page 20).
Use the ▼▲ keys to select a workout time limit. For example, if you set the workout
time limit to 20 minutes, the EFX allows users to specify a workout between 1 and 20
minutes. Users would not be able to specify a time longer than 20 minutes.
Note: The touch-sensitive keys can be gently pressed and held to view several
selections. The longer the key is held down, the faster the numbers scroll past.
Important: Take into account that the user will get an additional five-minute cool-
down period appended to his or her workout, so adjust the time limit accordingly.
SETTING A PAUSE TIME LIMIT
Setting a pause time limit is useful because the EFX exits the program and returns to
the Precor banner at a predetermined interval after the user stops pedaling.
Use the ▼▲ keys to set a pause time limit between 1 and 120 seconds (two minutes).
VIEWING THE ODOMETER, HOURS OF USE, SOFTWARE
VERSION AND ERROR LOG
The display console keys that you need to press to view the odometer, the num-
ber of hours the EFX has been in use, the software version and any error codes,
are as follows:
RESET, ▲, ▼
Note: The number keys, 6 and 5, may be pressed instead of using the ▲ and ▼
keys, for example: RESET, 6, 5. Remember to begin at the Precor banner. After
pressing RESET, the next key in the sequence must be pressed within ½ second.