Precor EFX556i User Manual

page 3
COMMERCIAL PRODUCTS DIVISION
SAVE THESE INSTRUCTIONS
• Never place your hand(s) or feet in the path of the roller arm because
injury may occur to you or damage may occur to the equipment. Refer
to Diagram 1.
• Do not use accessory attachments that are not recommended by the
manufacturer—such attachments might cause injury.
• Do not rock the unit. Do not stand on the display console or casing.
• Do not attempt to service the EFX
®
yourself other than the assembly and
maintenance instructions found in this manual. Refer to Obtaining Service .
• Do not overexert yourself or work to exhaustion. If you feel any pain or
abnormal symptoms, stop your workout immediately and consult your
physician.
HAZARDOUS MATERIALS AND PROPER DISPOSAL
The EFX
®
556i has an internal battery which must be removed before the EFX
®
is
scrapped. The battery contains materials which are considered hazardous to the
environment. Proper disposal of the battery is required by federal law.
To remove the battery from the EFX
®
, take the following steps:
CAUTION: Unplug the battery recharger and disconnect it from
its receptacle at the rear of the EFX
®
.
Tools required: Phillips head screwdriver and hex wrench set.
1. Remove both the right and left rear covers from the EFX
®
.
2. Remove the top rear cover.
3. Unplug the black and red battery wires from the circuit board.
4. Separate the circuit board from the battery by removing four screws.
5. The battery is held in place with a metal bracket. Lift the battery away from
the bracket.
6. Dispose of the battery according to the federal Hazardous Waste Regulations.
SAFETY APPROVAL
When identified with the ETL-c logo, the EFX has been tested and conforms to
the requirements of CAN/CSA-E-335-1/2-94, Safety of Household and Similar
Electrical Appliances.
Diagram 1
Avoid injury from the roller arm
mechanism.
Front cover
Roller arm
IMPORTANT SAFETY INSTRUCTIONS
IMPORIMPOR
IMPORIMPOR
IMPOR
TT
TT
T
ANT SAFETY INSTRUCTIONSANT SAFETY INSTRUCTIONS
ANT SAFETY INSTRUCTIONSANT SAFETY INSTRUCTIONS
ANT SAFETY INSTRUCTIONS

Precor EFX556i Specifications

Performance

crossramp	25 degrees (fixed)
stride length	18 inches (46 cm)
resistance levels	1 - 20

Regulatory and Frame

frame	Powder-coated steel
regulatory approval	FCC, ETL, CE
power	Self

Weight and Dimensions

length	80 inches (203 cm)
width	30 inches (76 cm)
height	64 inches (184 cm)
weight	230 lbs (105 kg)
shipping weight	340 lbs (155 kg)