Remove supports and lower the treadmill
4. Connect the power cord and switch the power ON. Be aware that switching the power
ON will cause the incline platform to move and return to the level "0" position. (If you
used the side access method, see "Side access" on page 76 to upright the treadmill.)
WARNING: Keep hands and appendages clear of the lift platform assembly
before switching power ON. Switching power ON will cause the incline platform to
move to the level "0" Home position.
5. Access the service menu (51765761) and select the INCLINE TEST. Increase the
incline level enough to lift the treadmill frame off the supports.
6. Remove the supports and clear any other items that might either block the treadmill
from lowering or may be damaged as the treadmill lowers.
7. Lower the incline to level "0".
Operation Verification
8. Use the service menu INCLINE TEST to raise the incline to the maximum level to
expose the jackscrew threads. Then clean and apply a thin layer of synthetic lubricant
to the jackscrew.
Lubricate the lift motor jackscrew
9. Verify the treadmill incline operation from minimum to maximum levels. Verify that the
movement is smooth and that there are no unusual noises etc. Go to the Error Log
and make sure that there are no new active incline function related error codes.
10. Reinstall the left and right trim side covers see "Covers and Panels Replacement" on
page 80.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 172
6 Replacement Procedures
Lift Platform Replacement
To Next Page
Loading...
Need help?
General