Power Cord Replacement
About
This procedure provides instruction to replace the power cord.
ID Description
Power Entry Assembly
Power Cord
ON/OFF SW Circuit Breaker
Procedure
Review entire procedure before starting.
Removal Instructions
1. Switch the power OFF and unplug
1
the power cord.
TIP: For easier access, raise the incline to maximum before removing input power.
Access the service Hardware Validation (51765761) and use the
CROSSRAMP/INCLINE Test to raise the incline and then remove power.
1
Disconnect a device power cord plug or cable connector from the power receptacle or out-
let.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 111
6 Replacement Procedures
Power Cord Replacement
To Next Page
Loading...
