Legacy Frame - "Legacy Take-up Roller" Installation
Legacy Frame with "Legacy Take-up Roller" Installation
Use this procedure to install the legacy frame take-up roller onto a legacy frame weldment.
Review entire procedure before starting.
1. Clean the running belt, deck, and Take-up roller.
2. Insert the Take-up roller through the running belt so that the roller shaft end with the
hole and slot inserts is on the left side and the end with the flat sided roller shaft is on
the right.
CAUTION:Make sure the Take-up roller does not drag across the deck surface
while inserting through the running belt causing damage to the deck surface.
3. Set the Take-up roller into the left and right frame mounting brackets.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 182
6 Replacement Procedures
Take-up Roller Replacement
To Next Page
Loading...
