1. On P62, P80, and P82 consoles, the Maintenance > Operating Condition para-
meter must be reset from the Inspect condition to the Normal condition. After reset-
ting the Operating Condition to Normal, the ASL state will change from solid yellow to
the solid blue state.
2. Then go to the CPA
1
Event Log and clear the error code by selecting the Clear con-
trol.
Note:Clearing the CPA Event Log does NOT clear the error codes from the Event
Log.
1
Touchscreen console Control Processing Assembly.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 241
7 Troubleshooting
Active Status Light (ASL)
To Next Page
Loading...
Need help?
General