Assembly and Installation Tips
Unpacking boxes
l Place part and assembly boxes as close to the installation location as possible.
l Keep all individual part and assembly fastener hardware together. Do not intermix or use
fastener hardware for other than the intended part installation.
Fastener Tips
l Keep fastener hardware with the intended part or assembly: Each training app and
optional shipping box contains all the parts and fasteners required to assembly and install that
item. Keep all fasteners shipped with a part together. Do not interchange, mix, or use fasten-
ers from one part to install a different part. Doing so will make it difficult to complete the build
and if a fastener is missing, make it difficult to know which fastener type is missing and needs
replacement.
IMPORTANT: Do not interchange optional and training app part fasteners. When unpack-
ing part boxes, keep the fasteners with the part and do not intermix with other parts. This
will make it easy to assemble and identify any missing fasteners.
:
See Also
"Introduction" on page1
"Assembly and Installation" on page10
"Floor Anchoring Requirements" on page27
9
3 Getting Started
Assembly and Installation Tips
To Next Page
Loading...
