Prestige APS25Z User Manual

Installaon and Reference Guide
2018 Voxx Electronics Corporaon. All rights reserved. APS25Z_RevA_08/18
2 Wire Harness Colors and Funcons
2 Main Input / Output Connector
3 Door Lock Connector
4 External Components
4 Shock Sensor
5 LED / Valet Programming Buon
4 System Operaon
4 Remote Operaon
4 Alarm Override Procedures
5 Setup Opons
5 Remote Programming
6 Security Control
APS25Z
Vehicle Security / Keyless Entry System
8 System Programming
8 Programming Mode Entry / Exit
9 Feature Bank Opons
9 Dome Light
9 Silent Arm and Disarm
9 User Selectable LED
9 System Diagnoscs
9 Troubleshoong Trigger Zones
9 Adjusng Shock Sensor
11 Wiring Diagrams
11 Door Lock Connecons
14 Starter Kill Relay
25 Full System Connecons
Thank you for trusng Presge products! If you are a consumer, please note:
Professional installaon is strongly recommended.
This manual assumes the installer has adequate knowledge of the following experse. Therefore, it does not
cover these topics in detail:
• 12-volt electronics
• Tesng and verifying circuits
• Making safe and lasng wiring connecons
• Factory ignion, power, lighng, data bus and sensing systems
• Factory systems and components to avoid
• Safe wire roung, circuit protecon and product placement
• Access to vehicle-specic technical informaon
In addion, this manual assumes the installer has the proper tools, skill and facilies to perform a professional installaon.
Performing an improper installaon could result in damage to the vehicle or its components, improper system funcon,
unsafe vehicle operaon or physical injury. Such instances would not be covered by the vehicle manufacturer's warranty,
nor by Voxx Electronics, Inc.
Detailed Descripons Quick Reference

Prestige APS25Z Specifications

General

Operating Range	Up to 1500 feet
Number of Remotes Included	2
Remote Color	Black
Engine Start	Yes
Engine Stop	Yes
Door Lock/Unlock	Yes
Trunk Release	Yes
Remote Start	Yes
Keyless Entry	Yes
Alarm	Yes
Starter Kill	Yes
Power Window Control	No
Smartphone Control	No
System Type	2-Way

Summary

Wire Harness Colors and Functions

Main Input / Output Connector

Details the 11-pin main connector wires, their functions, and connections for the alarm system.

Door Lock Connector

Explains the 2-pin connector for door lock functions and its wiring for remote activation.

Setup Options

Bank 1: Add / Remove Remote Controls

Instructions for programming and deleting remote controls from the system's memory.

Security Control (Bank 2)

Configuration options for various system features like locks, arming, and illumination.

System Programming

Programming Mode Entry and Exit Procedure

Step-by-step guide to enter and navigate the system's programming modes using ignition and button.

Bank 1: Transmitter Programming Options

Details on programming remote controls via specific button presses for basic functions.

Bank 2: Security Options

System Diagnostics

Wiring Diagrams

Door Lock Connections (Negative/Positive Trigger)

Door Lock Connections (Single-Wire Multiplex)

Door Lock Connections (Reverse-Polarity/Aftermarket)

Starter Kill / Anti-Grind Relay Connections