Prestige APS25Z - System Diagnostics

APS25Z_RevA_08/18
10
Quick Reference: System Programming & Diagnoscs
Silent Arm and Disarm
Program the Presge system to arm and disarm without nocaon beeps. (The siren will sound if the system is
triggered while armed.)
1. Turn the ignion ON then OFF.
2. Press and release the valet/programming buon three (3) mes. The system will respond with one (1) beep for ON or
two (2) beeps for OFF.
User Selectable LED
This feature will control whether the LED is ON or OFF when the system is Armed/Locked. This will be selectable in
feature programming OR on-the-y without entering the programming feature banks.
1. Turn the ignion ON, OFF, ON, OFF.
2. Press and hold valet buon for ve (5) seconds.
The system will respond with one (1) beep for ON or two (2) beeps for OFF.
Adjusng the Shock Sensor
1. Arm the system, wait 5-10 seconds, then with an open palm carefully apply impact to areas of the vehicle to test the
shock sensor’s sensivity.
2. To adjust, turn the adjustment knob on the shock sensor counter-clockwise for less sensivity; clockwise for more
sensivity.
3. If the proper sensivity sll cannot be achieved, re-locate the shock sensor.
Troubleshoong Trigger Zones
Test the doors, hood, trunk, and shock sensor to ensure they trigger the security system. Once triggered, the LED ashes
to indicate the trigger source:
1 Shock
2 Trunk / Hood
3 Door