Prestige APS25Z - Wire Harness Colors and Functions; Main Input; Output Connector

APS25Z_RevA_08/18
2
Detailed Descripons: Wire Harness Colors and Funcons
5. RED – 12-Volt Input (+)
The RED wire connects to the vehicle’s primary 12-Volt (+) wire to power the system.
Vericaon: The power wire registers 12-Volt (+) at all mes.
Note: Before making this connecon, remove all module fuses unl the system is completely connected.
1 2 3 4 5 6 7 8 9 10 11
6. BLACK – Ground Input (-)
The BLACK wire connects to a reliable vehicle ground (-) source to power the system.
Vericaon: The vehicle ground (-) source wire registers ground (-) at all mes.
Note: Before making this connecon, remove all module fuses unl the system is completely connected.
4. WHITE/BLACK – Siren Output (+)
The WHITE/BLACK wire supplies 12-Volt (+) to power the siren. Aer mounng the siren, connect its BLACK wire to a
reliable ground source, and connect the BROWN wire to the siren’s RED wire.
Main Input / Output Connector (11-pin connector) See page 15 for the full system diagram.
These wires are listed in order of their placement in the harness connector.
1. WHITE – Parking Light Relay Output (Internal Relay Pin 30)
At its default seng, the WHITE wire supplies 12-Volt (+) or Ground (-) to the vehicle's park light wire based on the
connecon of the relay input (WHITE/RED wire).
Vericaon: The vehicle parking light wire registers 12-Volt (+) or Ground (-) when the park lights are turned on.
Note: This wire can be programmed to perform the Trunk Release Output funcon by changing its opons. Refer to
Bank 2, Feature 6 on page 8.
2. WHITE/RED – Parking Light Relay Input (Internal Relay Pin 87)
The WHITE/RED connects to vehicle 12-Volt (+) or Ground (-) to supply the relay output (WHITE wire).
Vericaon for default seng:
• If the vehicle parking light wire registers 12-Volt (+) when the park lights are on, connect the WHITE/RED wire to a
constant 12-Volt (+) vehicle wire.
• If the vehicle parking light wire registers Ground (-) when the park lights are on, connect the WHITE/RED wire to a
reliable vehicle ground source.
Note: This wire can be programmed to perform the Trunk Release Output funcon by changing its opons. Refer to
Bank 2, Feature 6 on page 8.
21. DARK BLUE – Trunk Release Output (-)
At its default seng, the DARK BLUE wire connects to the vehicle trunk release wire or relay and supplies Ground (-)
when acvated from the remote control.
Vericaon: The vehicle trunk release wire registers 12-Volt (+) or Ground (-) when the trunk release buon is acvated.
Note: This wire can be programmed to perform the Parking Lights Output funcon by changing its opons. Refer to
Bank 2, Feature 6 on page 8.