CONTROLS/INSTRUMENTS
7. Push on upper section of rocker switches to
inflate lumbar support bellows inside the seat
backrest, and push on lower section of rocker
switches to deflate bellows.
NOTE: Rear and front rocker switches are
respectively for lower and upper lumbar support
bellows.
Seat belts - Driver’s seat
Each driver’s seat is equipped with a retractable
seat belt as required by State, Provincial and
Federal regulations. To fasten, pull seat belt out
of the retractor and insert the latch plate into the
buckle until it clicks. No special adjustment is
required since the reel device is self-adjusting. If
seat belt operation becomes defective, report to
Manufacturer's Service Center.
NOTE: The seat belt must be pulled out slowly
and continuously, otherwise it will lock the reel
before the latch plate reaches the buckle. If this
happens, allow the belt to retract completely and
repeat the procedure correctly.
WARNING: A snug fit with the lap belt
positioned low on the hips is necessary to ensure
motorist's safety. Belt should not be worn twisted;
avoid pinching belt and/or belt hardware in seat
mechanism. Do not wear belt over rigid or
breakable objects, such as eyeglasses, pens, or
keys as these may cause injuries.
CAUTION: Never bleach or dry clean safety
belt.
To unfasten belt, press red button in center of
buckle and allow belt to retract. If belt does not
fully retract, pull it out and check for kinks or
twists. Make sure that it remains untwisted as it
retracts.
FIGURE 37 18029
WARNING: Seat belts should always be worn
by motorists using seats supplied with belts since
this is required by most State and Provincial laws.
Passenger seats
Passenger seats may be equipped with grip
handles, ashtrays, newspaper holders, tables,
audio control modules and footrests.
18028
To Next Page
Loading...
Need help?
General
