CONTROLS/INSTRUMENTS
PREHEATING SYSTEM
TIMERS (AUXILIARY)
(Optional)
The timer, located on R.H. lateral console (see
page 2-22 items 5 & 5A), is used to program the
starting and stopping time of the preheating
system. One of two optional Timers (Espar or
Webasto) may be installed in your vehicle. The
system indicator light, located on dashboard (see
item #28 on page 2-7) illuminates when system is
functional. The following offers system
descriptions for both timers.
CAUTION: The preheating system should not
operate for more than one hour before starting
engine as this could discharge batteries.
WARNING: Preheating system must not
operate when vehicle is parked inside or during
fuel fill stops.
NOTE: Preheating system uses the same fuel
as the engine.
In case of failure:
1. Shut off and turn on again.
2. Check main circuit breaker and overheating
switch (Espar) or overheat fuse (Webasto).
3. Have system repaired in a specialized shop.
ESPAR (41 000 BTU)
FIGURE 64 18045
Setting the time and weekday for the first
time.
Press
key briefly.
12:00 flashes on the display.
Set the clock time with < or >.
The time is stored as soon as it stops flashing.
Then the weekday flashes. Set the current
weekday with < or >. It is stored as soon as it
stops flashing. When the ignition is switched on,
the clock time and weekday are displayed
continuously. When the ignition is switched off,
the display goes out after 15 seconds.
Setting the clock time and weekday.
Press
key and hold it down until the clock
time flashes. Proceed as described above. If you
only want to change the clock time, press the
key after setting the clock time to skip weekday
adjustment.
After changing the weekday, flashing duration of
the weekday can be reduced by pressing the
key.
Heating without preselection when ignition is
‘’Off’’.
Heating symbol
= Observe operating display
Switching on heater. To switch on heater,
press
key briefly. Operating display
appears.
Changing the heating duration once only.
After power-on: To reduce heating duration:
Press < key. To increase heating duration (to
max. 120 minutes): Press > key.
Changing the heating duration
permanently. Do not switch on
. Press the
< key and hold it down (approx. 3 seconds)
until the display appears and flashes. Release
key briefly. Then set the heating duration
using the < or > key. The new heating
duration is set when the display disappears.
To Next Page
Loading...
Need help?
General
