CONTROLS/INSTRUMENTS
3. You can get instant heat...
with the button
5, which switches your heater
on (or off) immediately. The green light is on
while the heater is switched on.
4. ... or you can program the heater to come
on up to 24 hours ahead.
Press button ‘’1’’6 - and the display shows the
time at which the heater will start. You can alter
starting time by pressing button
7 (backwards)
or
8 (forwards). The longer you press the
button, the faster the display changes. The last
few minutes are set accurately by quick pushes.
The display fades after 20 secs. The symbol 1
remains in the display, and the yellow light stays
on. Your starting time is now activated.
5. Button ‘’2’’9 10allows you to program a
second starting time
Press button ‘’2’’1112, which de-activates starting
time 1. Then proceed as in (4).
The activation of the second starting time is
indicated by the symbol 2.
6. Do you want to check (or activate) your
starting time?
Press button ‘’1’’1314 or ‘’2’’1516 briefly. The
display shows, for 20 secs., the programmed
starting time. This activates the timer to start the
heater at the time shown.
7. Do you want to cancel a programmed start?
Press button ‘’1’’1718 or ‘’2’’1920 briefly. The
appropriate number in the display goes out,
together with the yellow light.
To Next Page
Loading...
Need help?
General
