CONTROLS/INSTRUMENTS
3. You can get instant heat...
with the button
, which switches your heater on
(or off) immediately. The green light is on while
the heater is switched on.
4. ... or you can program the heater to come
on up to 24 hours ahead.
Press button ‘’1’’ - and the display shows the time
at which the heater will start. You can alter
starting time by pressing button
(backwards)
or
(forwards). The longer you press the
button, the faster the display changes. The last
few minutes are set accurately by quick pushes.
The display fades after 20 secs. The symbol 1
remains in the display, and the yellow light stays
on. Your starting time is now activated.
5. Button ‘’2’’ allows you to program a second
starting time
Press button ‘’2’’, which de-activates starting time
1. Then proceed as in (4).
The activation of the second starting time is
indicated by the symbol 2.
6. Do you want to check (or activate) your
starting time?
Press button ‘’1’’ or ‘’2’’ briefly. The display
shows, for 20 secs., the programmed starting
time. This activates the timer to start the heater
at the time shown.
7. Do you want to cancel a programmed start?
Press button ‘’1’’ or ‘’2’’ briefly. The appropriate
number in the display goes out, together with the
yellow light.
To Previous Page
Loading...
Need help?
General
