Troubleshooting and Maintenance 21
Section 4: Troubleshooting &
Maintenance
A. TROUBLESHOOTING
Generally, when a malfunction or an abnormal condition
occurs, the READY LED will keep blinking and printing and
communication between the host and printer will stop.
After the problems have been solved, press CANCEL to
continue printing.
Problems with media
Blinking Indicators READY and MEDIA
Possible
Problems Solutions Remarks
Missing gap Check the media If you use continuous
path media, check your
Check the application software
position of and driver.
label sensor. You should select
Continuous.
Media out Supply the media
roll
Media not Install the media
installed roll
Media jam Fix the jam
If everything is OK, perform a label sensor calibration.
To Next Page
Loading...
