Getting Started 5
Buttons
There are three buttons on the panel; each of them has at least
two basic functions.
Press the button and
Under normal turn on the power
Button condition simultaneously
Feeds a label. Performs self test
and prints out the
configuration report.
1. Stops the printing Performs media
process. calibration.
2. Resumes printing
after button is
pressed again.
1. Interrupts and Resets the settings
deletes the current at E2PROM.
print job.
2. Requests that the
printer start again
after an error has
been solved.
Important
It is highly suggested that you perform a media calibration
Note:
using the Pause Button as described above:
- after the first installation of labels.
- after you change to a different type or size of media
(Before calibration, the media and ribbon should be loaded
properly and the label sensor moved to the correct position).
To Next Page
Loading...
