98 PROGRAMMING MANUAL 100962 G PUBLICATION DATE 24 JUN 2008.DOC
• Press the ARROW DOWN button to see
message by message and to leave the Error message menu.
• If no messages are displayed, this means that no Errors have
occurred.
• If you don‘t want to erase the Fault messages,
press the ARROW DOWN button.
• Press the YES and ENTER button if you want to
erase the Error messages.
• If you don‘t want to see the Fault statistics,
press the ARROW DOWN button.
• If you want to see the Fault statistics, press the
ENTER button.
• The Fault Statistics are an accumulation of Errors messages
that have appeared over a long period.
• The Statistics can be reset at the Service Menu, by a Reset
of the Cycle counter.
• With this information the technician has an indication on
which parts an intervention will be needed.
The List with Statistics.
No Drain : E1 + E2 + E37
Door Switch : E6 + E7 + E8 + E9
Bimetal / Spring : E10 + E56
No Fill : E11 + E40
No Heating : E13 + E14
Thermic : E18 + E19 + E20 + E36
Temp Sensor : E25
Level Sensor : E24
Mitsubishi Alarm : E26 + E27 + E28 + E29 + E30
Loc k Active : E54 + E55
• For washing machines with Frequency Inverter Controlled
motor only.
• By this function it‘s possible to switch on the power for the
inverter if a technical intervention is needed.
• By selecting YES, the power of the inverter is switched on.
S:Erase Fault
Messages? No
S:Output Power
Inverter : Off
S:View Fault
Statistics?
S:No Drain
0 x
To Next Page
Loading...
