100962 G PUBLICATION DATE 24 JUN 2008.DOC PROGRAMMING MANUAL 39
5.3. STEP | : PROGRAM FUNCTIONS
T SELECT THE PROGRAM NUMBER
• Insert the desired program number.
• Program 1 to 99 can be selected.
• Press the ENTER button as a confirmation.
T ENTER THE PROGRAM NAME
• The Program Name is displayed at the start of a new cycle.
By the program name, the operator can see which kind of
wash program has been selected.
• If you DO NOT want to change the name of the wash
program, press the ARROW DOWN button.
• If you want to change or create a new name for a wash
program, press the ENTER button.
• With the ARROW LEFT or RIGHT button you can select
the character position.
• With the ARROW UP or DOWN button you can select
the desired character.
• By pressing the ENTER button, the dashes will disappear.
• Press the ARROW DOWN button to go to the next menu
item
Attention
!
The Name of the program is written into the EEPROM
memory at the moment that you leave the Program Menu.
T VIEW A PROGRAM
• In Program View you can look to the Program Settings,
without making changes.
• Press the ARROW DOWN button if you don‘t want to see
the program Over-View.
• Press the ENTER button if you want to see the program
Over-View.
Attention
!
In the program Over-View Menu, at the end of a Wash
Program Step, Press the ENTER button to see
the next step. See also } °
P:Give Program
Number :
P:Name Prog XX:
_ _ _ _ _ _ _ _ _ _
P: Program N°XX
View
!
!
To Next Page
Loading...