Primus FF10 - Step 5: Programming the Drain Step; Selecting Drain;Extraction Steps; The Drain Sequence

100962 G PUBLICATION DATE 24 JUN 2008.DOC PROGRAMMING MANUAL 67
5.6. STEP  : PROGRAMMING THE DRAIN STEP
This paragraph gives a detailed explanation about programming the
Drain/Extraction Sequences.
After programming the wash step, the drain step still has to be programmed.
ATTENTION
!
YOU DON’T HAVE TO PROGRAM A DRAIN SEQUENCE BEFORE AN EXTRACTION SEQUENCE AS
THE WATER WILL AUTOMATICALLY BE DRAINED AT THE EXTRACTION SEQUENCE
T SELECTING THE DRAIN/EXTRACTION STEP
Depending the machine type, you have more or less functions.
• For a new step, the first sequence that is displayed is
the Drain sequence (default).
• Select the desired Drain step sequence from the list by
pressing the ARROW LEFT or RIGHT button.
• Press the ENTER button to confirm your selection.
• You can also use the ARROW DOWN button if you
accept the pre-programmed default value.
T THE DRAIN SEQUENCE
• Only available on washing machines with both : a normal
Open and a normal Closed Drain valve.
• You can select Drain Valve 1 or 2.
• The default Drain valve is Drain valve 1.
• You have to select the desired Drain Valve by pressing the
ARROW LEFT or RIGHT button.
• Press the ENTER button for confirmation.
• The Drain Sequence can be programmed between 0 and 9.5
minutes in steps of 0.5 minutes.
• The default time is 0.5 Minutes.
• Programming a time of 0 minutes : the Drain step will not be
functional (cfr No Drain)
• Insert the desired Drain sequence time. Press the ENTER
button for confirmation.
Drain
|
Extract
|
Low Extract
|
Hi
g
h Extrac
t
|
No Drain
|
Static Drain
Drain
|
Extract
|
Low Extract
|
Hi
g
h Extrac
t
|
No Drain
|
Static Drain
P:Pr XX Step XX
Drain valve : 1
P:Pr XX Step XX
Time : 0,5 Min
P:Pr XX Step XX
Drain
1 | 2 | 1+2
!