100962 G PUBLICATION DATE 24 JUN 2008.DOC PROGRAMMING MANUAL 35
• Only for MB90 – 140 – 180.
• At the end of the wash cycle, the Inner Door of the Drum is
positioned automatically at the hole Outer Door Tub.
• If the Auto Position system should get broken, you can
switch off the Auto Position System.
Then the operator has to position the drum manually as a
standard MB-machine.
• Yes is the default value.
• Confirm by pressing the ENTER button.
Attention
!
Look inside the tub through the door glass before unlocking
the outer door, check that the inner door is positioned correctly
• You can erase all the wash programs at once.
• This function should only be used at the installation of a new
Full Control Wash Computer and if you want to ensure that
no old programs stay in the memory of the computer.
• Select Yes or No and you have to confirm by
pressing the ENTER button.
• By selecting YES, a new request for confirmation is
displayed. C: Delete all Programs ? No
• Press the YES and ENTER button to confirm once more.
• All the memory Blocks will be cleared one by one.
• If you want to make use of the 15 Standard wash programs,
these standard programs must be loaded into the Wash
Program Memory of the Full Control Computer.
• Press the ENTER button if you want to Load the Standard programs.
• Then you can Select the language of the Wash Program name.
• By the Wash Program Name the operator knows which kind
of wash process the program corresponds with.
• You can select the Language from a list by pressing the
ARROW LEFT or RIGHT button and you have to confirm by
the ENTER button.
• Then a Confirmation is asked before the First 15 wash
program’s will be loaded.
• By pressing the Yes and ENTER button, the 15 Standard
program’s will be loaded at the Program numbers 1 to 15.
• The Standard wash program‘s can be found in this manual
at chapter 7.
C:Erase All
Wash Pro
?
C:Load Standard
Pro
rams?
C:Language
English
C:Load Program
1
15 ? No
C:Auto Position
Drum : Yes
To Next Page
Loading...
