56 PROGRAMMING MANUAL 100962 G PUBLICATION DATE 24 JUN 2008.DOC
T THE FINAL RINSE SEQUENCE
Only for Top Soap Hopper washing machines.
• No temperature can be programmed as a Last Rinse is only dedicated for cold (hard) water.
Top Soap Hopper washing machines
• 3 Inlets can be programmed. I1, I2, I5 and I6 are available.
• A machine with 3 water supply inlets
functions with Cold Hard
water, Cold Soft water and Warm Soft water .
£ The suggested inlet valve is I1 Cold Hard water
.
• A machine with 2 water supply inlets
functions with Cold Soft
water and Warm Soft water.
£ The suggested inlet valves are I1 + I6 Cold Soft water
.
• The suggested inlet valves are related to the temperature
and the soap box.
• Insert the desired inlet valves. Press the ENTER button for
confirmation.
Attention
!
If you insert other inlet valves than the suggested ones,
problems can occur at the water fill process.
• The suggested Water Level corresponds with the Normal
High water level.
• The suggested water level depends on the machine type.
• Check the corresponding table paragraph 3.4.
• The water level can only be programmed within certain limits.
• Insert the desired water level. Press the ENTER button for
confirmation.
• The suggested drum speed value depends on the machine
type.
• Check the corresponding table paragraph 3.4.
• The drum speed value can only be programmed within
certain limits.
• Insert the desired speed value. Press the ENTER button for
confirmation.
Prewash
Wash
Cooldown
Rinse
Final Rinse
Soak
Flush
S
ra
No wash
P:Pr XX Step XX
Inlet : _ _ _ _
P:Pr XX Step XX
Level : _ _
P:Pr XX Step XX
RPM : _ _
!
To Next Page
Loading...
