LinePrinter Plus Proprinter XL Emulation
143
FF Valid At TOF
• Enable. Performs a form feed when the host sends a Form Feed
command and the printer is at the top of form.
• Disable. Will not perform a form feed when the host sends a Form Feed
command and the printer is at the top of form.
Character Set
Specifies a character set as shown in the page 144. To use one of these sets,
choose the desired group heading (such as European Sets) and press
ENTER. Then choose the desired set within that group (such as Roman 8)
and press ENTER. Both the group and the desired set will be starred to
indicate your selection. Character sets are shown in detail in the
Character
Sets Reference Manual
.
20 CPI Condensed
Compressed print characters are narrower than the normal character set.
This is helpful for applications where you need to print the maximum amount
of information on a page.
• Enable. Prints characters about 60 percent the width of normal
characters when compressed print is chosen by the host computer.
• Disable. Does not compress print widths, even if condensed print is
chosen by the host.
Alt. Set 80-9F
Determines whether the printer processes ASCII codes hex 80 through hex
9F as control codes or as printable characters.
To Next Page
Loading...
