11
13. Attach the Assist Arm Tether (34) to the Backrest
Support (8) and the Assist Arm (9) with two M8 x
2
5mm Shoulder Bolts (44).
S
lide two 15-pound Resistance Bands (33) onto
the indicated tubes on the sides of the Backrest
Support (8) and the Assist Arm (9). Note: The
tubes closest to the Rear Upright (5) are for stor-
ing the Resistance Bands.
15. Insert an Adjustment Pin (29) into the Front To p
Frame (4). Attach the Adjustment Pin to the Front
Top Frame with an M4 x 12mm Screw (49).
14. Hold the Dip Arm (10) behind the Front Top
Frame (4) as shown. Attach the Dip Arm with two
M10 x 100mm Button Bolts (31) and two M10
Nylon Locknuts (35).
Do not overtighten the
Nylon Locknuts; the Dip Arm must be able to
pivot easily.
See Drawing 14A. Attach a Dip Handle (13) to the
Dip Arm (10) with a Dip Frame Cap (27) and an
M10 x 53mm Button Bolt (40).
Repeat this step
with the Dip Handle (13).
33
8
44
44
34
9
5
10
31
35
4
31
29
4
49
33
13
14
15
14A
13
27
40
10
13
To Next Page
Loading...
