9
7. Attach the Backrest Support (8) to the Rear
Upright (5) with an M10 x 62mm Button Bolt (30)
a
nd an M10 Nylon Locknut (35). D
o not tighten
the Nylon Locknut yet.
Attach the Backrest Support (8) to the Front Top
Frame (4) with four M10 x 53mm Button Bolts
(40) and four M10 Nylon Locknuts (35).
8. Insert the Pull-up Frame (7) into the Rear To p
Frame (6). Attach the Pull-up Frame to the Rear
Top Frame with four M8 x 15mm Button Screws
(39) and two M8 x 62mm Button Screws (41).
Tighten the M10 Nylon Locknuts (35) used in
steps 2–8.
7
8
4
35
35
8
30
35
40
40
40
5
39
39
41
41
39
6
7
9. Attach a Pull-up Handle (12) to the Pull-up Frame
(7) with four M8 x 20mm Button Screws (43).
Slide a Pull-up Handle Cap (28) over the Pull-up
Handle and press the Pull-up Handle Cap into the
Pull-up Frame.
Attach the other Pull-up Handle (12) to the
Pull-up Frame (7) in the same manner.
12
12
43
28
7
9
43
To Next Page
Loading...
