pro.point PROCUT45 - Disposal and Troubleshooting; Troubleshooting Guide

V1.1 PROCUT45 PLASMA CUTTER 8611303
Visit www.princessauto.com for more information 35
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
Contact your local municipality for a list of disposal facilities or
by-laws for electronic devices, batteries, oil or other toxic liquids.
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does
not function properly or parts are missing. If unable to do so,
have a qualified technician service the tool.
PROBLEM(S)
POSSIBLE CAUSE(S)
SUGGESTED
SOLUTION(S)
Pilot plasma
is not stable
during
operation.
Compressed air is too low
or too high.
Adjust pressure.
Electrode of cutting torch
or nozzle is burnt.
Replace electrode or
nozzle.
Connection between
ground cable and
workpiece is poor.
Connect firmly.
Cutting speed is too slow.
Adjust speed.
Cut is at
wrong angle.
Nozzle or electrode is
burnt.
Replace nozzle or
electrode.
The installation position
of nozzle and electrode
do not match.
Correctly install both.
Cutting speed is too high. Slow down cutting speed.
Nozzle axis is not plumb
with the plane.
Adjust the torch angle.
Cut is too
wide, cut
quality is
poor.
Cutting speed is too slow. Accelerate cutting speed.
Tor c h’s electrode or
nozzle is burnt.
Replace electrode or
nozzle.
Cutting speed is too high. Slow cutting speed.
Review
Wrong type of nozzle
used.
Replace with a suitable
nozzle.