8611303 PROCUT45 PLASMA CUTTER V1.1
32 For technical questions call 1-800-665-8685
and must be changed as it nears saturation. It should be installed
close as possible to the air intake of the plasma cutter.
TECHNIQUE TIPS
• To cut thin material reduce the amperage until you get the
best quality cut.
• Use the correct size tip orifice for the amperage being used.
• For straight cuts use a straight edge or cutting buggy as a
guide. For circles, use a template or circle cutting
attachment
• Check that the front end consumable parts of the plasma
cutting torch are in good condition.
PIERCING
Hold the torch at an angle to the workpiece, pull the trigger to
start the arc and slowly rotate it to an upright position.
When sparks are exiting from the bottom of the workpiece, the
arc has pierced through the material. When the pierce is
complete, proceed with cutting.
SAFETY TRIGGER OPERATION
The torch supplied with the machine has a new safety trigger
design. Just pull back on the trigger whilst increasing your grip
and you will feel the trigger move to the ON position. When
you release the pressure it will return to the OFF position.
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is
efficient, easier to control and will have fewer problems.
2. Inspect the tool fittings, alignment, hoses and power supply
cord periodically. Have damaged or worn components
repaired or replaced by an authorized technician. Only use
identical replacement parts when servicing.
To Next Page
Loading...
