pro.point PROCUT45 - Parts Breakdown

8611303 PROCUT45 PLASMA CUTTER V1.1
36 For technical questions call 1-800-665-8685
PROBLEM(S)
POSSIBLE CAUSE(S)
SUGGESTED
SOLUTION(S)
Workpiece is
not cut
through.
The cutting speed is too
rapid.
Slow down the cutting
speed.
Torch electrode or nozzle
is burnt out.
Replace electrode or
nozzle.
Cut thickness exceeds
the limit of the cutting
unit.
Replace with high-power
plasma cutting unit.
Cutting mouth is not
vertical.
Adjust cutting mouth
angle.
Leak from the gas circuit
reduces gas/air flow.
Examine and repair the
gas circuit.
PARTS BREAKDOWN