TECHNICAL SPECIFICATIONS
PERFORMER 980060 07/01/02
3-1
ITEM DIMENSION/CAPACITY
Engine speed 2400 rpm (high speed) Water Pump ON
1900 rpm (low speed) Water Pump OFF.
900 rpm (idle speed) Water Pump OFF.
Water pump rpm 1625 rpm
Vacuum pump rpm 2650 rpm
Water flow rate 5.0 GPM (maximum)
Water pump pressure 1000 PSI (maximum)
Vacuum relief valve 14” Hg (13” Hg - Performer 405)
Waste tank capacity 66 gallons (55 gallons to shut-off)
Console weight 964 lbs. (1010 lbs - Performer 405)
Console weight (with waste tank & accessories) 1209 lbs (1626 lbs. If waste tank is full)
1255 lbs. (1672 lbs. If waste tank is full - Performer 405)
TORQUE VALUES
Engine hub 720 inch lbs 60 foot/lbs
Vacuum pump hub 192 inch/lbs 16 foot/lbs
JET SIZING:
PROCHEM recommends floor tool tip sizing not exceed a total of “.06”. Using larger jet sizes
on your PERFORMER/PERFORMER 405 may reduce cleaning temperatures.
Example: Tri-jet wand uses three 9502 jets (95° spray angle w/ 02 orifice).
02 x 3 = 06
When using two floor tools while cleaning with this unit, PROCHEM recommends that each
tool tip size does not exceed a total of “.045”.
Example: Tri-jet wand uses three 95015 jets (95° spray angle w/ 015 orifice).
015 x 3 = 045……….045 x 2 tools = 09
Upholstery tool jet size: 80015
Stair tool jet size: 9502
To Next Page
Loading...
