www.usaprocom.com
19200307-01E
OPERATION
THERMOSTAT CONTROL OPERATION
ALL MODELS
TO TURN OFF GAS TO APPLIANCE
Shutting Off Heater
Turn control knob clockwise to the
OFF position.
Shutting Off Burner Only
(pilot stays lit)
Turn control knob clockwise to the
PILOT position.
MANUAL LIGHTING PROCEDURE
1. Remove lower front panel.
2. Follow steps 1 through 5 under Lighting
Instructions, page 17 or 18.
3. With control knob pressed in, strike match.
Hold match to pilot until pilot lights.
4. Keep control knob pressed in for 30 sec-
onds after lighting pilot. After 30 seconds,
The thermostatic control used on this
model differs from standard thermostats.
You set standard thermostats to a specic
temperature (such as 72 degrees); the
control of this heater establishes a “comfort
level”. In order for the thermostat to operate
effectively, the heater should be the main
source of heat in the ROOM. Follow the
instructions for lighting the heater, and
turn the knob to the HIGH position. When
the room reaches the desired comfort
level, rotate the control knob clockwise
slowly to the point where the main burner
extinguishes (this point on the dial will
change depending on room temperature),
then back counter-clockwise -just until
the ame reignites. Leave the knob in
this position. As the room temperature
increases, the burner will automatically
return to LOW setting or extinguish. When
the room temperature cools, the heater
will come back on. If left at this set-point
the thermostat will turn the main burner
off and on as needed to maintain the
temperature at this comfort level setting.
release control knob. Follow step 8 under
Lighting Instructions, page 17 or 18.
5. Replace lower front panel.
Any safety screen,guard, or barrier re-
moved for servicing an appliance must
be replaced prior to operating the heater
To Next Page
Loading...
