EasyManuals Logo

ProForm 400 X Treadmill User Manual

ProForm 400 X Treadmill
22 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
1
1
STEP-BY-STEP CONSOLE OPERATION
Before operating the console, make sure that the
power cord is properly plugged in (see page 10).
Next, make sure that the
reset/off circuit breaker,
located on the treadmill frame
near the power cord, is in the
reset position.
Stand on the foot rails of the treadmill. Find the clip at
-
tached to the key (see the drawing above), and slide
the clip onto the waistband of your clothes. Next, insert
the key into the console. A tone will sound and the
three displays will light. Important: In an emergency
situation, the key can be pulled from the console,
causing the walking belt to slow to a stop. Test the
clip by carefully taking a few steps backward; if the
key is not pulled from the console, adjust the posi-
tion of the clip.
Follow the steps below to operate the console.
Insert the key into the console.
When the key is inserted, a tone will sound and
the three displays will light.
Press the Start button or the Speed + button to
start the walking belt.
A moment after the button is pressed, the walking
belt will begin to move. Hold the handrails and
begin walking.
As you exercise, change the speed of the walking
belt as desired by pressing the Speed buttons.
Each time a button is pressed, the speed setting
will change by 0.1 mph; if a button is held down,
the speed setting will change in increments
of 0.5
mph. Note: The console can display speed and
distance in either miles or kilometers (see
SPEED DISPLAY on page 12). For simplicity, all
instructions in this section refer to miles.
2
1
CAUTION: Before operating the
console, read the following precautions.
Do not stand on the walking belt when turn-
ing on the power.
Always wear the clip (see the drawing
above) while operating the treadmill.
Adjust the speed in small increments to
avoid sudden jumps in speed.
To reduce the possibility of electric shock,
keep the console dry. Avoid spilling liquids
on the console and place only a sealed
water bottle in the accessory trays.
Reset
Pulse Sensor
CONSOLE DIAGRAM
Note: If there is a thin sheet of
plastic on the console, remove it.
D
isplays
Key
Clip

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ProForm 400 X Treadmill and is the answer not in the manual?

ProForm 400 X Treadmill Specifications

General IconGeneral
BrandProForm
Model400 X Treadmill
CategoryTreadmill
LanguageEnglish

Related product manuals