ProGlove Mark 2 - DISPOSAL; CERTIFICATION; SAFETY; LVD TESTING AS PER:; COMPLIANCE WITH ENVIRONMENTAL PROTECTION:

40
Natural resources are used for the production of MARK 2
system. These may contain hazardous substances, which
could harm the environment. MARK 2 system corresponds
to the directive 2002/96/EC of the EUROPEAN PARLA-
MENT AND COUNCIL of 27 January 2003 regarding old
electronic and electric devices (WEEE). That is why MARK
2 system cannot be disposed of through the household
waste. If you have questions about a return or an envi-
ronmentally-friendly disposal, please contact ProGlove
support (contact data under chapter 10 “Support and Service”).
Carry out the following steps to decommission MARK 2
system:
1. Release MARK 2 from Wearables
2. Disconnect the connection cable from the Access Point
One S
3. Disconnect the mains plug from the Charging Station S
4. Properly dispose of Hardware and Wearables as elec-
tronic scrap
SAFETY / LVD TESTING AS PER:
IEC 60950-1:2005/AMD1:2009
IEC 60950-1:2005/AMD2:2013
IEC 60950-1:2005
EN 60950-1: 2006 / A11: 2009 / A1: 2010 /
A12: 2011 / A2:2013
COMPLIANCE WITH ENVIRONMENTAL PROTECTION:
2011/65/EU restriction of certain hazardous
substances in electric and electronic devices (RoHS).
FCC REQUIREMENT:
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
>No changes shall be made to the equipment without the
manufacturer’s permission as this may void the user’s
authority to operate the equipment
DISPOSAL CERTIFICATION