ProGlove Mark 2 - 868;915 MHZ - DATA TRANSFER

37
868/915 MHZ - DATA TRANSFER
PROBLEM CAUSE SOLUTION
Barcode data is not transferred. MARK 2 is not connected to the Access
Point One S.
 Scan the pairing barcode on the
Access Point One S.
MARK 2 is out of range of the Access
Point One Ss One S.

 Bring MARK 2 closer to Access Point
One S.
Access Point One S is defective.
Access Point One S must be replaced.
 More detailed information can be
found at proglove.com/support.
MARK 2 is defective.
MARK 2 must be replaced.
 More detailed information can be
found at proglove.com/support.
Different barcode data is
transferred.
The keyboard layout of the end device is
set with a different language.
 Adjust the keyboard layout of the


tool  under “Device
settings - USB keyboard layout,” adjust
the language.
868
(915)
MHz