ProLights CYBER192 - Fade Time Assign

9
CYBER 192
4. Press and hold [FIXTURES] button # 1.
5. While holding button # 1 press [FIXTURES] button # 2.
6. While holding [FIXTURES] buttons # 1 and # 2, press and hold MIDI/ADD button.
7. Release [FIXTURES] button # 1 rst before releasing [FIXTURES] button # 2.
8. Release [MIDI/ADD] button.
9. All FIXTURE LED indicators will ash to conrm successful copy.
10. Press and hold [PROGRAM] & [TAP SYNC] buttons times to exit mode.
3.4 FADE TIME ASSIGN (Optional Setup)
You can choose whether the board’s fade time during scene execution is implemented broadly to all out-
put channels or only to the Pan and Tilt movement channels. This is relevant because often you will want
gobos and colors to change quickly while not aecting the movement of the light.
1. Turn OFF the controller.
2. Hold the [BLACKOUT] and [TAP SYNC] buttons simultaneously.
3. Turn ON the controller.
4. Press the [TAP SYNC] button to toggle between the two modes. Either all channels (A) or select channel
Pan & Tilt only (P)
5. Press [BLACKOUT] and [TAP SYNC] to save settings. All LED’s will blink to conrm.