ProLights CYBER192 - Playback; Manual Run Scene; Running in Sound-Mode (Playback Scene); Running in Auto-Mode (Playback Scene)

CYBER 192
14
- 6 - PLAYBACK
Playback (Scenes)
6.1 MANUAL RUN SCENE
When power is rst turned ON, the controller will be in manual scene mode.
1. Make sure neither MUSIC TRIGGER nor AUTO TRIGGER LED’s on the LED display are on.
2. Select the program BANK that stores the scene you want to run manually by using the [BANK UP]/ [BANK
DOWN].
3. Press the SCENE button to run.
NOTE - If you are in programming mode you can also press and hold the PROGRAM button until the Pro-
gram LED goes o.
6.2 RUNNING IN SOUND-MODE
In the Sound mode, programs will be triggered by the sound using its built-in microphone. All scenes in
a Bank will chase.
1. Press the [MUSIC/BANK COPY] button until the MUSIC TRIGGER LED turns on.
2. Change BANK programs by using [BANK UP]/ [BANK DOWN] buttons if necessary.
3. Press the [MUSIC/BANK COPY] to exit.
6.3 RUNNING IN AUTO-MODE
In the Auto mode, programs will be triggered by controllers fade and speed time as set on the faders. All
scenes in a Bank will chase.
1. Press and hold the [AUTO/DEL] button until the AUTO TRIGGER LED turns on.
2. Change BANK programs by using [BANK UP]/ [BANK DOWN] buttons if necessary.
3. You can override the time between steps by moving the SPEED fader and the fade time of the step by
moving the FADE TIME fader. To revert to the programmed values, press the [PROGRAM] button once.
4. You can change Banks while in operation by using the [BANK UP]/ [BANK DOWN] buttons.
NOTE - A Chase can contain 240 scenes as steps. The term steps and scenes are used interchangeably.
6.4 BLACKOUT
The Blackout button brings all lighting output to 0 or o (also called the home position of the unit).
Playback (Chases)
6.5 MANUAL RUN CHASES
This function allows the user to manually step through each individual step in a chase.
1. Press and hold [PROGRAM] button for 3 seconds to enter programming mode.
2. Start a chase by pressing any one of the CHASE buttons.
3. Press the TAPSYNC/DISPLAY button to manually step through the chase.
4. Use the BANK buttons to scroll through the chases.
5. Press and hold the [PROGRAM] button for 3 seconds to exit programming mode.