ProLights CYBER192 - Programming; Create a Scene; Edit a Scene; Scene Copy

CYBER 192
10
- 4 - PROGRAMMING
A program (bank) is a sequence of dierent scenes (or steps) that will be called up one after another. In the
CYBER192, can be created 6 sets of chases containing 240 steps.
4.1 CREATE A SCENE
A scene is a static lighting state. Scenes are stored in banks. There are 30 bank memories on the controller
and each bank can hold 8 scene memories.
1. Press and hold the [PROGRAM] button for 3 seconds (g.4).
2. Select a [FIXTURES] (xture) to program.
3. Compose a look by moving the FADERS. (Changes in xture attribute such as colors and gobos.) Press
PAGE SELECT to access Channels 9~16 on the faders.
4. To program another FIXTURE press the [FIXTURES] button you have just nished programming then
select another [FIXTURES] button to program.
5. Repeat steps 2 ~ 4 until you have your look.
6. Move the [SPEED] and [FADE TIME] sliders to adjust the speed and fade time of the scene.
7. Tap [MIDI/ADD] button to prepare to store.
8. Choose a BANK (01~30). Use the Up and Down arrow Bank buttons to change if necessary.
9. Select a SCENES button to store. All LED’s will blink 3 times. The display will now display the bank and
scene number that is stored.
10. Repeat steps 2 ~ 8 to record more scenes.
11. To exit program mode, hold the [PROGRAM] button for 3 seconds. The controller will default to a BLACKOUT
when exiting the programmer.
NOTE - You can access channels 9~16 by pressing the Page Select button. This is necessary for xtures that
use more than 8 channels of control. When switching pages it will be necessary to move previously moved
faders up then down to activate.
4.2 EDIT A SCENE
1. Press the [PROGRAM] button for 3 seconds.
2. Locate the scene in the program BANK. Use BANK UP/DOWN to navigate program banks.
3. Select the SCENE in the program BANK to edit.
4. Adjust FADERS to change the look.
5. Press the [MIDI/ADD] button then the SCENE button again previously selected for editing.
NOTE - Remember the scene number on the controller that you will edit, otherwise, you could overwrite
the contents of another scene.
Deselect Blackout if LED is lit.
4.3 SCENE COPY
1. Press the [PROGRAM] button for 3 seconds.
2. Locate the scene in the program BANK. Use BANK UP/DOWN to navigate program banks.
3. Select the SCENE in the program BANK to copy.
4. Locate the destination scene in the program BANK. Use BANK UP/DOWN to navigate program banks.
5. Press the [MIDI/ADD] button then the new SCENE button to copy to.