CYBER 192
16
- 7 - MIDI
7.1 MIDI OPERATION
The controller will only respond to MIDI commands on the MIDI channel when it is set to full stop. All MIDI
control is performed using Note on commands. All other MIDI instructions are ignored. To stop a chase,
send the blackout on note.
1. Press and hold the MIDI/ADD button until the third and fourth digits on the LED display blink.
2. Select the MIDI control channel (1~16) via the BANK UP/DOWN buttons to set.
3. Press and hold the MIDI/ADD button to store midi setup settings.
This is the Channel that the controller will receive MIDI note commands.
MIDI note FUNCTION (turn on/o)
00 - 07 SCENE 1 - 8 in BANK 1
08 - 15 SCENE 1 - 8 in BANK 2
16 - 23 SCENE 1 - 8 in BANK 3
24 - 31 SCENE 1 - 8 in BANK 4
32 - 39 SCENE 1 - 8 in BANK 5
40 - 47 SCENE 1 - 8 in BANK 6
48 - 55 SCENE 1 - 8 in BANK 7
56 - 63 SCENE 1 - 8 in BANK 8
64 - 71 SCENE 1 - 8 in BANK 9
72 - 79 SCENE 1 - 8 in BANK 10
80 - 87 SCENE 1 - 8 in BANK 11
88 - 95 SCENE 1 - 8 in BANK 12
96 - 103 SCENE 1 - 8 in BANK 13
104 - 111 SCENE 1 - 8 in BANK 14
112 - 119 SCENE 1 - 8 in BANK 15
120 CHASE 1
121 CHASE 2
122 CHASE 3
123 CHASE 4
124 CHASE 5
125 CHASE 6
126 BLACKOUT
To Next Page
Loading...